SDO200 SERIES DIGITAL STORAGE OSCILLOSCOPE

SDO200 SERIES DIGITAL STORAGE OSCILLOSCOPE

share
  • Products Details


SDO200 SERIES

DIGITAL STORAGE OSCILLOSCOPE



Features


. Dual-channel oscilloscope with 25MHz signal generator (model s)

. 100MHZ, 150MHz, 200MHz bandwidth

. Dual-channel independent 1GS/s real-time sampling rate

. 20M memory depth

. Support 30 Automatic Waveform Measurements

. 6-digit High-precision Frequency Counter

. FFT Spectrum Analysis

. Communicate with PC via USB Device interface, support SCPI   

   and LabVIEW functions, provide free computer software and

   some programming development demos, so you can remotely

   control the instrument and conduct secondary development.

. 7-inch TFT LCD display


. Dual-channel oscilloscope with waveform generator (SDO210S, SDO220S only)


Technical DataSDO210/SDO210SSDO220/SDO220S
Input
Input couplingDC, AC, GND
Input inpedance1MΩ±2%, in parallel with 12pF±5pF

Probe attenuation coefficient

1x, 10x, 100x, 1000x
Maximum input voltage400V (DC+AC, PK - PK)
Chanel to chanel isolation50Hz: 100:1 / 10MHz: 40:1
Time delay between channel (Typical)
150ps
Vertical
Analog bandwidth100MHz200MHz
Rise time (Typical)≦3.5ns
≦1.75ns
Channels22
Vertical scale8 bits
Bandwidth limit (Typical)20MHz
Low frequency response (AC coupling, -3dB)≧ 10Hz (on BNC)
DC gain accuracy±3%
DC accuracy (average)Delta volts between any two averages of ≧16 waveforms acquired with the same scope setup and ambient conditions (ΔV): ±(3%reading + 0.05V/div)
Displacement±1V (2 mV/div~100 mV/div), ±60V (200 mV/div~10 mV/div)
Waveform invertedON/OFF
Horizontal
Time scale2 ns/div~1000 s/div/div, step by 1-2-5
Timing accuracy±100 ppm
Interval (ΔT) Accuracy (DC-100MHz)

Single : ±(1 interval time + 100ppm x reading + 0.6ns)

Average>16: ±(1 interval time + 100ppm x reading+ 0.4ns)

Sampling
Sampling rate range0.5 S/s~1G S/s
Interpolation(Sinx)/x
Acquisition modeNormal, Peak detect, Averaging
Memory depth20M
Trigger
Trigger level rangeInternal: ±4 div from the screen center
Trigger level accuracy (Typical)Internal: ±0.3 div
Trigger displacementAccording to record length and time base
Trigger hold-off range100 ns~10 s
50% level setting (Typical)Input signal frequency ≧ 50Hz
Edge triggerSlope, Rising, Falling
Video triggerModulation: Support standard NTSC, PAL and SECAM broadcast system
Line number range 1~525 (NTSC) and 1-625 (PAL/SECAM)
Measure
CursorΔV, ΔT, ΔV and ΔT between cursors, auto cursor
Automatic measurement

Period, Frequency, Mean, PK-PK, RMS, Max, Min, Top, Base, Amplitude, Overshoot,   Preshoot, Rise Time, Fall Time,+PulseWidth, -PulseWidth, +Duty Cycle, -Duty Cycle, Delay A→ B   , Delay A→ B   , Cycle RMS, Cursor RMS, Screen Duty, Phase, +PulseCount, -PulseCount, RiseEdgeCnt, FallEdgeCnt,

Area and Cycle Area.

Waveform Math+,-, ×, ÷, FFT
Waveform storage16 waveforms
Lissajous figureFull bandwidth, ±3 degrees phase difference
Waveform Generator (S model only)
Waveform
Standard WaveformsSine wave, square wave, ramp wave, pulse wave, arbitrary wave
Arbitrary WaveformsSinc, exponential rise, exponential decline,Gaussian more than 160 kinds
Waveform Characteristics
Sine

Bandwidth: 0.1Hz~25MHz

Bandwidth flatness (relative to 1 kHz Sine wave, 1Vpp, 50Ω)

≤10MHz: ±0.3dB ≤25MHz: ±0.5dB

SquareBandwidth: 0.1Hz~5MHz, Rise/fall time:<30ns, Overshoot:<5%
Ramp

Bandwidth: 0.1Hz~1MHz

Linearity: < 2% of peak output (typical 1 kHz, 1 Vpp, symmetry 50%)

Symmetry: 0% to 100%

PulsePeriod: 200ns to 1Ms

Pulse Width: 100ns

Rise/fall time: >12ns

Overshoot: <5%

ArbitraryBandwidth: 0.1Hz~5MHz, Waveform length: 8k
General Characteristics
Bandwidth25MHz
Real-time Sample125M Sa/s
Amplitude(50Ω)0.005Vpp   ~ 3Vpp
DC offset range (High Z)± (3V – amplitude Vpp/2)
Frequency resolution0.01%
Channel1
Waveform Length8k
Vertical resolution14 bits
Output impedance50 Ω (typical)
Display
Display type7-inch TFT LCD
Display resolution800 horizontal x RGB x 480 vertical pixels
Interface
Standard interfaceUSB Host, USB Device
Probe compensation signal output
Output voltageAbout 5V with the peak to peak voltage
FrequencySquare wave of 1 KHz
Power supply
Power supply voltage100V~240VAC RMS, 50Hz/60Hz, CAT II
PowerMax. 16W
Fuse2A, T class, 250V
Mechanical specifications
Size301mm(W) x 152mm(H) x 70mm(D)
Weight1.1kg